Vauxhall Ampera Owner's Manual page 169

168 Vehicle care
Air only hose: Turn the selector
switch clockwise to g.
9. Press m to turn the tyre repair kit
on.
Sealant and air hose: The
compressor will inject sealant and
air into the tyre. The pressure
gauge will initially show a high
pressure while the compressor
pushes the sealant into the tyre.
Once the sealant is completely
dispersed into the tyre, the
pressure will quickly drop and
start to rise again as the tyre
inflates with air only.
Air only hose: The compressor will
inflate the tyre only with air.
10. Inflate the tyre to the
recommended inflation pressure
using the pressure gauge.
Tyre and loading information label
3 162.
Tyre pressures 3 190.
The pressure gauge may read
higher than the actual tyre
pressure while the compressor is
on. Turn the compressor off to get
an accurate pressure reading.
The compressor may be turned
on/off until the correct pressure is
reached.
Air only hose: If you inflate the tyre
to a pressure higher than
recommended, you may release
the excess pressure by pressing
f, until the proper pressure
reading is reached.
Note
If the recommended pressure
cannot be reached after
approximately 25 minutes, the
vehicle should not be driven farther.
The tyre is too severely damaged
and the tyre repair kit cannot inflate
the tyre. Remove the power plug
from the accessory power outlet and
unscrew the inflating hose from the
tyre valve.
11. Press m again to turn the tyre
repair kit off.
Be careful while handling the tyre
repair kit as it could be warm after
usage.
Sealant and air hose: The tyre is
not sealed and will continue to
leak air until the vehicle is driven
and the sealant is distributed in
the tyre.