Starting And Stopping The - Vauxhall Ampera Owner's Manual

■ Audio system
■ Power outlets
Power windows will operate for up to
10 minutes or until any door is
opened.

Starting and stopping the

vehicle
Starting
Move the shift lever into P or N. The
propulsion system does not start in
any other position.
Note
Do not try into shift to P if the vehicle
is moving as the electric drive unit
could be damaged. Shift into P only
if the vehicle is stopped.
The radio remote control must be
within the vehicle. Press the brake
pedal and press button m. If the radio
remote control is not within the
vehicle or something interferes with
the transmitter, a message will be
displayed in the Driver Information
Centre (DIC).
Radio remote control 3 20.
A welcome, ready, and goodbye
audio message is given out in the
vehicle and animated on the
instrument cluster when opening the
driver's door upon entry, when the
vehicle is ready to be driven and when
the ignition is switched off. The
instrument cluster will display an
active fuel or battery gauge, along
with an audio start-up cue, if the
vehicle is ready to be driven.
Driving and operating
Starting the vehicle with a low radio
remote control battery
If the vehicle does not start due to a
low radio remote control battery, a
message will be displayed in the DIC.
To still drive the vehicle proceed as
follows:
1. Open the instrument panel
storage and remove the rubber
mat.
2. Extend the key blade and place
the blade into the slot.
3. With the vehicle in P or N, apply
the brake pedal and press m on
the instrument panel.
107