Brother RJ-4030 Software Manual page 15

Descriptions for the numbers in the print data on the previous page are provided in the following table.
For details on each command, refer to
No. Command Name
１
Invalidate
2 Initialize
Switch dynamic
3
command mode
Additional media
4
information command
Print information
5
command
Various mode settings
6
(1Bh+69h+4Dh+00H)
7 Specify margin amount
Select compression
8
mode
9 Raster data
Print command with
10
feeding
"4. Printing Command
Details".
A 350-byte invalidate command is sent.
The "initialize" command is sent.
The printer is switched to raster mode.
Send this command before sending raster data to the printer.
Additional media information on the media size is sent.
This is the command for "4" × 6" (102 mm × 152 mm)".
Media size information for the print data is sent.
This is the command for "4" × 6" (102 mm × 152 mm)" die-cut
labels.
This is the command for specifying settings such as cut options.
Since there are no cut options with this model, it is unnecessary
to send this command.
Since a margin amount cannot be specified with die-cut labels,
this command is sent with a margin amount of 0.
TIFF compression mode is selected.
Raster data continues.
Since one page will be printed, this is sent at the end of the first
page.
- 11 -
Raster Command Reference
Description
2. Print Data