Table of Contents
Advertisement
e. For heated tanks installed in plastic (e.g. Corian®) counter
tops, the counter material must be protected from the heat of
the warmer in order to prevent discoloration and/or
deterioration. Wellsloks are not suitable for this purpose.
The installer should contact the manufacturer or distributor of
the countertop material for specific installation instructions.
D. ELECTRICAL INSTALLATION
1. Refer to the nameplate. Verify the electrical service power.
Voltage and phase must match the nameplate specifications.
Wiring the warmer to the wrong voltage can severely damage the
unit or cause noticeably decreased performance.
2. Available electrical service amperage must meet or exceed the
specifications listed on the provided specification sheet .
3. Warmer and control unit must be connected to an appropriate
building ground. Ground connection will be marked "GND" or " " .
E. PLUMBING INSTALLATION
For use in the State of Massachusetts, this appliance must be
installed in compliance with Massachusetts Fuel Gas and
Plumbing Code CMR 248.
1. IMPORTANT:
All plumbing installations must be performed by a qualified
plumber.
2. Some jurisdictions may require an approved back-flow preventer
in the drain line. It is the responsibility of the plumber to determine
such requirement, to provide the proper back-flow prevention
device, and to properly install the required back-flow preventer.
3. For AUTOFILL units: Some jurisdictions may require an
approved back-flow preventer in the water supply line. It is the
responsibility of the plumber to determine such requirement, to
provide the proper back-flow prevention device, and to properly
install the required back-flow preventer.
Autofill supply must be connected to a COLD WATER line only.
INSTALLATION (continued)
NOTE: Damage caused by
leaks due to improper
installation is NOT covered by
warranty.
The ground lug of this
appliance must be connected
to a suitable building ground.
IMPORTANT:
Contact a licensed electrician
to install and connect
electrical power to the
appliance.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
IMPORTANT: Electrical
installation other than as
specified on the specification
sheet will void the UL listing,
and may void the warranty.
NOTE: Plumb connections
must be made in compliance
with all Federal, State and
Local Plumbing Codes and
Ordinances.
7
CAUTION:
SHOCK HAZARD
Advertisement
Table of Contents
