Messages (Sms) / Mailbox; Reading New Messages; Sending Messages; Entering The Service Number - Blaupunkt Antares T60 Operating Instructions Manual

MESSAGES / MAILBOX

Messages (SMS) / Mailbox

You can send and receive SMS messages
with your Radiophone.

Reading new messages

New messages are indicated in the display
with a symbol. When a new message is
received you will hear a beep.
When you have received a new message,
press SMS.
The message will appear in the display.
To "page through" the messages,
press / .
If you want to place a call to the sender,
press .
Once you have read the message,
press CLR.
A selection will appear in the display. You can
choose whether you want to delete the mes-
sage or store it in the memory.
Press / to select the corresponding
option.
Press OK.
If you select No , the message will be put into
storage.

Sending messages

Press OK in the telephone mode.
The DSC menu will appear in the display. The
cursor will mark Setup .
to select Menu .
Press
Press OK.
The menu will appear in the display. The cur-
sor will mark Mailbox .
to select Messages .
Press
Press OK.
Press to select Output .
The OUTPUT menu will appear in the dis-
play.
38
Press to select New .
Press OK.
Now use the buttons 0 - 9 to enter the
message. For more information on how
to enter text, refer to "Entering names/
telephone numbers" in the chapter enti-
tled "Phone book".
Note:
Message texts can have up to a maximum of
160 characters.
Press OK.
Use the buttons 0 - 9 to enter the phone
number.
Press OK.
Press / to either send, store or send
and store the message.
Press OK.
The message will be sent. You will return to
the Message output menu.

Entering the service number

To be able to send messages, you must first
enter your provider's service number. The
service number is usually stored on the SIM
card and used automatically.
If you have to enter the service number again
or would like to change it,
press OK in the telephone mode.
to select Menu .
Press
Press OK.
Press to select Messages .
Press OK.
Press to select Parameters .
Press OK.
Press to select Service no.
Press OK.
Enter the service number with the but-
tons 0 - 9.
Press OK.
The PARAMETERS menu will appear in the
display.