Chapter 2; Device Overview - Billion BiPAC 2071 User Manual

Chapter 2

Device Overview

BiPAC 2071
The Description of each labeled part is described in the table below.
AC Outlet / AC
Pass-thru (only
available in BiPAC
2072 model)
1.0 DET LED
Power LED
PLC (Powerline
Link/Act) LED
ETH (Ethernet
Link/Act) LED
Sync Button
Reset Button
Ethernet Port
Power Plug / AC
Power Cord
1.0 DET LED
Power LED
PLC LED
ETH LED
Sync Button
Reset Button
Ethernet Port
Power Plug
Allow the direct plug-in of another Ethernet device.The AC Pass-thru allows
the filtering of noise to prevent HomePlug AV Network interference.
Note: The AC Outlet only support devices that use 6A (maximum)
electric current.
Blink when detect the presence of other HomePlug 1.0 devices that have
the transmission rate of 14 or 85 Mbps.
Note: Due to the incompatibility of HomePlug AV 200 with HomePlug
1.0 devices, the presence of the HomePlug 1.0 devices within the
powerline network will thus reduce the performance of your powerline
network.
Lit when the device is power on. Lit off when power is off or when the
device has entered power saving mode.
Lit when a network has been established. Blink when powerline data is
transmitted or received.
Lit when an Ethernet data signal is transmitted or received.
Used to establish a LAN network with other Ethernet devices.
Press this button to restore the device configuration to its default setting.
Connect the HomePlug AV device with an Ethernet device (eg. PC or
modem router) & the Ethernet cable included.
Plug into an AC outlet for power supply and to build a powerline network
with other HomePlug AV devices.
BiPAC 2072
4
AC Outlet /
AC Pass-thru
(only
available in
BiPAC 2072
model)