Re-Enabling Dualview Under Windows Xp - Barco IMAGETILE System Manual

Re-enabling DualView under Windows XP

If you have disabled DualView using the method described on the
previous page and decide you want to re-enable it, follow the steps
listed below.
1. Open the "Display Properties Control Panel" by right clicking on the
desktop, then select "Properties".
2. Click on "Settings" tab. Double click on the rectangle that
represents the BarcoMed Imaging Board you are working with to
bring up its property page. Click on the "BARCO Metheus
Configuration" tab.
3. Select "Enable DualView" from the "Monitor Configuration" drop
down menu (see figure 52 below). Click "OK", twice. Your system
will automatically shutdown and restart.
Figure 52: Barco Metheus Configuration Tab – Enabling DualView
4. When your machine comes back up, you will need to re-set up
your ImageTile displays with the desired display settings.
If you wish to re-enable DualView on more than one BarcoMed
3MP2FH Imaging Board repeat steps 1 – 4 above for each board.
System manual ImageTile
BarcoMed software driver installation
74