Table of Contents
Advertisement
15. If the Wizard has successfully installed the drivers for all of the
displays supported by your BarcoMed 3MP2FH imaging board(s),
the Wizard will prompt you to click "Finish" (see figure 46).
Clicking on "Finish" will exit the Wizard and restart your computer
now. Click "Cancel" to exit the Wizard and restart your computer
at a later time. If the installation failed, click "Finish" to exit the
Wizard (see figure 48) and try reinstalling the drivers following the
steps above or following the step outlined in the section
"Reinstalling or Updating your BarcoMed Drivers" found later in this
chapter.
Click "Yes" to confirm reboot when you see Figure 47.
System manual ImageTile
BarcoMed software driver installation
Figure 46
Figure 47
Figure 48
69
Advertisement
Table of Contents
