Advertisement
Quick Links
Replacement Instructions
1. Ensure the area is safe for maintenance to be performed in accordance with area
requirements and local regulations.
2. Remove power from the GDX-350 transmitter.
3. Loosen, unscrew, and remove the sensor head cap using the sensor replacement tool (P/N:
5600-0002) as shown below.
Figure 1. Sensor Head Cap and Sensor Replacement Tool
4. Remove the old sensor assembly (sensor and printed circuit board), noting the position of
the notch found on the PCB header.
5. Install the new replacement sensor module.
IMPORTANT: Be sure to orient the PCB header notch so that it engages into its
socket.
6. Replace the sensor cap securely onto the sensor head using the sensor replacement tool.
GDX-350 Transmitter
Instructions for Replacing
a Calibrated Sensor
Instruction: 5600-9002
Revision: 1
September 13, 2012
Advertisement
Related Manuals for Bacharach GDX-350
Summary of Contents for Bacharach GDX-350
- Page 1 1. Ensure the area is safe for maintenance to be performed in accordance with area requirements and local regulations. 2. Remove power from the GDX-350 transmitter. 3. Loosen, unscrew, and remove the sensor head cap using the sensor replacement tool (P/N: 5600-0002) as shown below.
- Page 2 GDX-350 Transmitter Replacing a Calibrated Sensor 7. Apply power to the GDX-350 transmitter. NOTE: The new sensor is automatically recognized by the GDX-350 transmitter. The sensor identification screen is displayed at power-up after the new sensor has been installed. 8. After installing the new sensor, the sensor identification screen is displayed: •...