Table of Contents
Advertisement
g
Press the "Start/Stop" button to start
sewing.
*
Guide the fabric lightly by hand.
h
Press the "Start/Stop" button again to stop
sewing.
i
Press the "Thread Cutter" button to trim
the threads.
→ The needle will return to the up position
automatically.
CAUTION
• Do not press the "Thread Cutter" button after
the threads have been cut. Doing so could
tangle the thread or break the needle and
damage the machine.
• Do not press the "Thread Cutter" button when
there is no fabric set in the machine or during
machine operation. The thread may tangle,
possibly resulting in damage.
Note
• When cutting thread thicker than #30, nylon
thread, or other decorative threads, use the
thread cutter on the side of the machine.
j
When the needle has stopped moving, raise
the presser foot and remove the fabric.
Memo
This machine is equipped with a bobbin thread
sensor that warns you when the bobbin thread
is almost empty. When the bobbin thread is
nearly empty, the machine automatically
stops. However, if the "Start/Stop" button is
pressed, a few stitches can be sewn. If the
warning displays, re-thread the machine
immediately.
■ Using the Foot Controller
You can also use the foot controller to start and stop
sewing.
CAUTION
Do not allow fabric pieces and dust to collect in
the foot controller. Doing so could cause a fire or
an electric shock.
Memo
• When the foot controller is being used, the
"Start/Stop" button has no effect on sewing.
• The foot controller cannot be used when
embroidering. The foot controller can be
used for sewing utility and decorative
stitches when the embroidery unit is
attached.
a
Pull the retractable cord out from the foot
controller to the desired length, and then
insert the foot controller plug into its jack
on the machine.
b
a Foot controller
b Foot controller jack
Note
Do not pull retractable cord out beyond the red
mark.
SEWING
a
2
45
Advertisement
Chapters
Table of Contents
