Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3
Pass the thread under the guide on the
presser foot.
1 Guide on presser foot
2 Notch in guide on presser foot
• Make sure that the thread securely passes
through the notch in the guide on the
presser foot.
4
Securely pass the thread through the groove
in the thread cutter, and then lightly pull the
thread to cut it.
1 Groove in thread cutter
● If the thread is not correctly passed
through the groove in the thread cutter,
the message "Wiper error" appears and
the needle cannot be threaded. Be sure to
securely pass the thread through the
groove.
● If enough thread is not pulled out, the
thread cannot be pulled through the
thread cutter.
Note
5
Press the automatic needle-threading
button.
• The threader moves back away from the
needle. The thread is pulled through the
needle eye.
• The wiper comes out and catches the
thread between the needle and the
threader.
• The threader goes back to the original
home position.
This completes the upper threading for
needle bar 1.
Thread the remaining needle bars in the same
way.
Note
● If the needle bar to be threaded is not
moved to the embroidering position, the
needle cannot be threaded with the
automatic needle-threading mechanism.
For the remaining needle bars, perform the
following operation to move the needle
bar to the embroidering position before
trying to thread the needle.
Upper Threading 61
2
Advertisement
Table of Contents
Troubleshooting
