Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Error messages
When erroneous operations are performed messages and advice on operation will be displayed on the
LCD. Follow what is displayed. If you press
message is displayed, the message disappears.
No
1
2
3
4
5
6
7
8
Error Message
There is a possibility that the data for the selected pattern is corrupted.
Either the start/stop button or the reverse/reinforcement stitch button
was pushed at a LCD screen other than the sewing LCD screen.
The start/stop button was pressed without connecting the foot controller
when the setting for adjusting the stitch width using the sewing speed
controller is set to "ON" .
You have selected a pattern for which the stitch width control cannot
be used. (page 105)
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
Upper thread broken.
Upper thread not set up correctly.
Upper thread has run out.
CAUTION
Be sure to rethread the machine. If you press
button) without rethreading the machine, the thread tension may be
wrong or the needle may break and cause injury.
The machine is deleting a previously saved pattern while in embroidery
edit mode.
The start/stop button was pressed while the foot controller was
connected.
You tried to use the foot controller for embroidery.
You attempted to select a pattern after the USB media containing the
pattern has been disconnected, then reconnected.
or do the operation correctly while the error
Probable Cause
(Start/stop
Troubleshooting 177
5
Advertisement
Table of Contents
