Hardware Overview; Connectors; Led Indicators - Axis M3004-V User Manual

AXIS M3004-V Network Camera

Hardware Overview

Hardware Overview
1.
Dome cover
2. Control button
3.
microSD Card slot
4.
Network connector (PoE)
5.
Focus ring

Connectors

For technical specifications, see page 49.
Network connector - RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
NOTICE NOTICE NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network switch
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. For
information about regulatory requirements, see Regulatory Information, on page 2 .
SD card slot - A standard or high-capacity microSD card (not included) can be used for local recording with removable storage.
NOTICE NOTICE NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
• Resetting the product to factory default settings. See page 44.
• Connecting to an AXIS Video Hosting System service. See page 37. To connect, press and hold the button for
about 1 second until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 37. To connect, press and hold the button for
about 3 seconds.

LED Indicators

Color Indication
Unlit Connection and normal operation
Amber Steady during startup. Flashes during firmware upgrade.
5