Release 2.02; Release 2.00; Release 1.23A; Release 1.20 - Equinox Systems MEGAPORT/2 Read This First Manual

Release 2.02

Added diagnostics utility, megadiag, to release disk
Fixed problem that allowed erroneous flow control character initialization

Release 2.00

SVR4 pkgadd installation/removal
Installation changes for NCR and SVR4.2 Systems
POSIX compliance (test suites X/OPEN XPG3 and NIST PCTS)
full internal DDI/DDK compliance
added support for V.24 control signal extensions
enhanced megastty functionality

Release 1.23a

NCR Multiprocessor support added
MEGAPLEX/2 initialization corrected
Greater memory mapping flexibility (MEGAPLEX/2 uses full 32-bit address)
VPIX no longer supported

Release 1.20

Added transparent printer support
Performance enhancements
Improved hardware flow control
MEGAPLEX/2 support added
Enhanced diagnostics extensions

Release 1.10

Added a procedure to automate the device driver installation process
Added support for MEGAPLEX
Increased support to 240 ports
Corrected an intermittent condition which caused a panic when the cable was
disconnected
Changed initialization to start RTS at "off"

Release 1.0.1c

Initial release
MEGAPORT/2 & MEGAPLEX/2
Streams Release Notes 2.24
7