Table of Contents
Advertisement
Device Driver Version 2.00 and Higher
If you currently use version 2.00 or higher of the Equinox Streams device driver, run
the
pkgrm
driver was installed. Enter
driver. The
utility.
Do not rebuild the kernel at this time. The rebuild can be done after the new driver
is installed.
Once you have successfully completed at least one of the removal procedures dis-
cussed above, you are ready to proceed with driver installation.
Installing Version 2.24 Device Driver
Follow these steps after you have removed any previous device driver release:
Step 1 Run the
Step 2 The
Step 3 Enter the word
Step 4 A prompt displays listing the available package. Enter
to select the device driver packages:
<CR>
Step 5 The installation should continue in a normal manner from this point. Refer
to the sample installation provided in the SVR4 Streams Device Driver Software
Reference Manual, Equinox part number 560071/Rev A to guide you though the rest
of the installation procedure. After the installation is completed, the following
prompt displays:
Step 6 Type
Step 7 Reboot your system to begin using the new driver.
MEGAPORT/2 & MEGAPLEX/2
Streams Release Notes 2.24
command. A prompt displays if version 2.00 or higher of the device
utility removes packages that were installed with the
pkgrm
# pkgrm eqx
The following package is currently installed:
eqx Equinox Megaport/2 Megaplex/2 STREAMS Device Driver (Micro Channel) (i386) 2.xx
Do you want to remove this package [y,n,?,q]
command:
pkgadd
# pkgadd -d diskette1
command confirms your actions with the following prompt:
pkgadd
Type [ go ] when ready or [q] to quit:
go
go
1 eqx Equinox Megaport/2 STREAMS Device Driver
Type [ go ] when ready or [q] to quit:
followed by
q
followed by a carriage return to remove the device
Y
followed by
to continue:
<CR>
to exit the installation procedure.
<CR>
pkgadd
followed by a
1
4
Advertisement
Table of Contents
