Avocent AutoView 2020 Installer/User Manual page 38

28 AutoView 2020/2030 Installer/User Guide
CAUTION: Monitor damage can result from the use of Energy mode with monitors not compliant with
E S ®.
NERGY TAR
5. (Optional) Click Test to activate the screen saver test which lasts 10 seconds then returns you to
the Security dialog box.
6. Click OK.
To log in to your console (after screen saver has been activated):
1. Press any key or move the mouse.
2. The Password dialog box displays. Type your password, then click OK.
3. The Main dialog box displays if the password was entered properly.
To remove password protection from your console:
1. From the Main dialog box, click Setup - Security; the Password dialog box displays. Type your
password, then click OK.
2. In the Security dialog box, single-click and press
the box blank. Press
3. Single-click and press
Press
Enter
4. Click OK to eliminate your password.
To enable the screen saver mode with no password protection:
1. If your console does not require a password to gain access to the Security dialog box, proceed
to step 2.
-or-
If your console is password protected, see the previous procedure, then go to step 2.
2. Select Enable Screen Saver.
3. Type the number of minutes for Inactivity Time (from 1 to 99) to delay activation of the
screen saver.
4. Choose Energy if your monitor is E
CAUTION: Monitor damage can result from the use of Energy mode with monitors not compliant with
E S ®.
NERGY TAR
5. (Optional) Click Test to activate the screen saver test which lasts 10 seconds then returns you
to the Security dialog box.
6. Click OK.
NOTE: Activation of the screen saver mode disconnects the user from a server; no server is selected. The status
flag displays Free.
.
Enter
or double-click in the Repeat box. Leave the box blank.
Enter
.
or double-click in the New box. Leave
Enter
®
S compliant; otherwise select Screen.
NERGY TAR