Table of Contents
Advertisement
RF-503 OPERATION INSTRUCTIONS
A. REMOTE CONTROL TRANSMITTER OPERATION
The remote control transmitters (XT-57) included with the RF-503 offer the code rolling feature
which will prevent illegal use of a code-grabber with an attempt to record the code of your
transmitter.
In addition to normal ON/OFF alarm operation, the unique four button transmitter allows you to
"customize" certain alarm functions from the transmitter for your particular vehicle, or for
changing conditions, such as traffic, the environment, etc. The transmitter has three buttons
marked, I, II, & III, and referred to in this manual as Button I, II, and III, plus a smaller button
marked "M". This button indicates MODE and will be explained wherever it becomes
necessary to use it throughout this manual.
1. ARM/DISARM
TO ARM THE RF-503
Press Button I once to arm. The vehicle
horn, or siren (*) will chirp one (1) time,
the parking lights will flash one (1) time, and
all doors will lock (**).
TO DISARM THE RF503
Press Button I once to disarm.
The vehicle horn, or siren (*)
will chirp two (2) times,
the parking lights will flash two (2)
times, and the doors will unlock (**).
NOTE (*): The RF-503 is capable of two methods for audible alarm trigger. You may choose
at the time of installation to honk the vehicle's horn, you may choose the standard electronic
siren, or both.
NOTE (**): Your vehicle must be equipped with power door locks. Optional relays may be
required. Please read the manual for other door lock functions and/or options that may be
controlled by the RF-503.
I
III
2
II
M
Advertisement
Table of Contents
