ATCOM NanoStation 2 Configuration Manual page 5

Setting boot_script_data...
Done. Restarting device...
Note: The re-flash will take about 3-5 minutes to complete.
2. Steps to re-flash using Linux:
1) Boot your Linux computer (or Live CD) and bring up a terminal window
(under "Applications", then "Accessories", then "terminal" on Ubuntu).
2) Make sure it is connected to the internet, then type the following to
download the files you will need:
sudo apt-get update
sudo apt-get install wget
wget http://dev.open-mesh.com/downloads/stable/firmware/open-mesh-f
lash
chmod +x open-mesh-flash
3) Type: sudo ./open-mesh-flash. You should see something like:
Usage:
./open-mesh-flash [ethdevice]
open-mesh firmware r2643
./open-mesh-flash [ethdevice] rootfs.bin kernel.lzma
and kernel
./open-mesh-flash -v
The 'ethdevice' has to be one of the devices that are part of the supported
device list which follows. You can either specify its name or the interface
number.
1: eth0
(No description available)
2: wmaster0
(No description available)
3: wlan0
(No description available)
4: any
(Description: Pseudo-device that captures on all interfaces)
5: lo
(No description available)
flashes embedded kernel + rootfs:
prints version information
flashes your rootfs
4