Related Manuals for ATCOM AXE-800P
Summary of Contents for ATCOM AXE-800P
- Page 1 ATCOM ATCOM Analog Analog Card Card AXE E E E - - - - 800 800P P P P ATCOM ATCOM ® ® ® ® Analog Analog Card Card AX Product Product Guide Guide Product Product Guide Guide Version: 1.1...
-
Page 2: Table Of Contents
The Installation of AXE-800P with Centos 6.0 Content C C C C ONTACT ONTACT ONTACT ATCOM ATCOM ............................2 2 2 2 ONTACT ATCOM ATCOM.................................................................................. C C C C HAPTER HAPTER HAPTER HAPTER 1 1 1 1 THE THE INTRODUCTION... -
Page 3: C C C C Ontact
ATCOM The Introduction of ATCOM Founded in 1998, ATCOM technology has been always endeavoring in the R&D and manufacturing of the internet communication terminals. The product line of ATCOM includes IP Phone, USB Phone, IP PBX, VoIP gateway and Asterisk Card. -
Page 4: C C C C Hapter Hapter 1 1 1 1 The
Traditional Calls/VoIP Calls Conference Hardware Hardware requiremen requiremen requirement t t t Hardware Hardware requiremen 500-Mhz Pentium III 64MB RAM 3.3V or 5V PCI 2.2 slot PCI card card card card dimension: dimension: dimension: dimension: 264mm (length) × 121mm (height) www.atcom.cn... -
Page 5: Hardware Configuration
If you want to use FXS port with AX800P, you have to provide 12V power for the card. If you want to use any module with AXE800P, you have to provide 12V power for the card. Please download the dahdi-linux for the card in atcom website. W W W W arning... - Page 6 Figure 2: AX-210S Figure 3: AX-210XS Figure 4: AX-210X Figure 5: SP400 www.atcom.cn...
-
Page 7: Axe-800P
Test Environment: asterisk-1.6.2.6 dahdi-linux-complete-2.4.1.2+2.4.1 Centos 6.0 AXE-800P+4AX-210X After inserting the card into your PCI slot and boot your server, please use the “lspci -vv” command to check the PCI bus compatibility. The correct output will like the following: ---------------------------------------------------------------------------------------------------------------------- 05:04.0 Communication controller: Tiger Jet Network Inc. Tiger3XX Modem/ISDN interface... - Page 8 Install asterisk 1) [root@localhost src]# tar -xvzf asterisk-xxx.tar.gz 2) [root@localhost src]# cd asterisk-xxx 3) [root@localhost asterisk-xxx]# ./configure 4) [root@localhost asterisk-xxx]# make 5) [root@localhost asterisk-xxx]# make install 6) [root@localhost asterisk-xxx]# make samples www.atcom.cn...
-
Page 9: Hapter 4 4 4 4 Software
Software Configuration Configuration 1. Please check if the AXE-800P driver has been loaded successfully, run cat /proc/interrupts command and you should see one line with "ax1600p". If you can not see "ax1600p", you can try to poweroff your server and replug AX-1600P into another PCI slot. - Page 10 ......;;; line="7 WCTDM/16/6 FXSKS (SWEC: MG2)" signalling=fxs_ks callerid=asreceived group=0 context=from-pstn channel => 7 callerid= group= context=default ;;; line="8 WCTDM/16/7 FXSKS (SWEC: MG2)" signalling=fxs_ks callerid=asreceived group=0 context=from-pstn channel => 8 callerid= group= context=default www.atcom.cn...
- Page 11 Blocked State pseudo default default In Service from-pstn default In Service from-pstn default In Service ..........from-pstn default In Service from-pstn default In Service www.atcom.cn...
-
Page 12: Hapter 5 5 5 5 Reference
C C C C hapter hapter hapter hapter 5 5 5 5 Reference Reference Reference Reference http://www.asteriskguru.com/ http://www.asterisk.org/downloads http://www.openippbx.org/index.php?title=Main_Page http://www.atcom.cn/ www.atcom.cn...