Pioneer SC-25 Operating Instructions Manual page 10

Application Operations (Continued)
4
Select the type of data to be received, then select "OK".
Select "Reverb" to receive the data for the room's reverb characteristics, "Group Delay" to receive the
data for the speakers' group delay characteristics and "MCACC Parameters" to receive the data for the
various MCACC parameters (measurements results).
Data transmission starts.
When reception finishes the received data appear.
Note
• The data used to display the reverberation characteristics graph (Reverb), the group delay characteristics
graph (Group Delay) and the MCACC parameters are not deleted even when the receiver's power is
turned off. However, for the data used to display the reverberation characteristics graph (Reverb) and the
group delay characteristics graph the data stored in the receiver is overwritten when the reverberations
are measured again. If you wish to display graphs of multiple sets of data, use the data transfer function to
store the data on a computer each time you measure the reverberations.
• In order to avoid malfunction, after the completion of the data transmission, unplug the RS-232C cable
connecting your PC and the receiver.
Type of data
10
Continue