1. Manuals
  2. Brands
  3. Patton electronics Manuals
  4. Control Unit
  5. IM1/F-128K
  6. User manual

Patton electronics IM1/F-128K User Manual

G.703 interface module
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

Enlarged version
MODEL IM1/F-128K
G.703 Interface Module
Part#: 07MIM1/F128-B
Doc#: 090141UB
Revised 08/12/99
An ISO-9001
Certified Company
SALES OFFICE
(301) 975-1000
TECHNICAL SUPPORT
(301) 975-1007
http://www.patton.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IM1/F-128K and is the answer not in the manual?

Questions and answers

Related Manuals for Patton electronics IM1/F-128K

Summary of Contents for Patton electronics IM1/F-128K

  • Page 1 MODEL IM1/F-128K G.703 Interface Module Part#: 07MIM1/F128-B SALES OFFICE Doc#: 090141UB (301) 975-1000 Revised 08/12/99 TECHNICAL SUPPORT (301) 975-1007 An ISO-9001 http://www.patton.com Certified Company...

  • Page 2: Warranty Information

    However, this is no guarantee that interference will not occur in a particular installation. If the Model IM1/F-128K does cause interference to radio or television reception, which can be deter-...

  • Page 3: General Information

    Patton Access Products. The G.703 network provides a 128K co-directional three level signal on FIFO a clear channel. The Model IM1/F-128K is capable of handling either network timing or modem timing, thereby realizing network extension or G.703 network replacement configurations.
  • Page 4 TIMED MODE CLOCK TIMING 2.5 CLEAR CHANNEL MODE FIFO The Model IM1/F-128K provides one data mode in which the inter- face passes data and timing, as described below: G.703 FIFO Clear Channel Mode: Data is passed at a128K rate. This does not preserve the byte integrity associated with Octet timing.

  • Page 5: Installation

    3.0 CONFIGURATION 4.0 INSTALLATION The Model IM1/F-128K is equipped with four DIP switches that allow con- Once the Model IM1/F-128K is properly configured, it is ready to install figuration of the unit to match your application. These DIP switches are located into Patton Model 1090, 1092, 1094A and 1095..
  • Page 6 With the card edge contacts aligned with the socket, firmly seat the module by using your thumbs to apply pressure To function properly, the Model IM1/F-128K requires two twisted pairs of directly to the right and left edges of the module faceplate.

  • Page 7: Fcc Class A

    APPENDIX A PATTON MODEL IM1/F-128K SPECIFICATIONS Applications: 128K G.703 co-directional PCM network extension or network replacement Connector: Symmetrically balanced pair, 4 wire RJ-45 female Interface: Entire module plugs into Patton Electronics Model 1090, 1092, 1094A and 1095. Operating Supports clear channel mode...

Table of Contents