Related Manuals for Patton electronics 3042
Summary of Contents for Patton electronics 3042
- Page 1 USER MANUAL MODEL 3042 (CTS TDM-V.24) Time Division Multiplexor, RS-232 Part #: 07M3042-A SALES OFFICE Doc #: 119001UA (301) 975-1000 Revised 3/26/01 TECHNICAL SUPPORT (301) 975-1007...
-
Page 2: Warranty Statement
The Model 3042 has been tested and found to comply with the limits for a Class A computing device in accordance with the specifica-... - Page 3 (301) 975-1007. Packages received without an RMA number will not be accepted . Patton Electronics’ technical staff is also available to answer any questions that might arise concerning the installation or use of your Model 3042. Technical Service hours: 8 A.M. to 5 P.M. EST, Monday through Friday.
-
Page 4: Operation
2.0 OPERATION The Patton 3042 (CTS TDM-V.24) is a Full Duplex, RS-232, Two Channel, Time Division Multiplexor with an independent switch selectable V.14/V.22 compliant Asynchronous to Synchronous Interface adapter on sub-chan- nel 1. The composite channel is designed to interface directly with a high speed synchronous MODEM via a straight through cable. -
Page 5: Installation
3.1 INSTALLATION Set switches to match the required configurations based on the diagrams below. The cabling between each device and the 3042 (CTS TDM-V.24) must be terminated with male connectors. Character Length and Stop Bit reduction only apply to channel 1 when it is selected for asynchronous operation. - Page 6 APPENDIX A TECHNICAL SPECIFICATIONS A.1 APPLICATIONS RS-232 Sync or Async 2 Sub-Channel Multiplexor A.2 CAPACITY Two Sync or One Sync and One Async RS-232 Terminals One Sync RS-232 MODEM A.3 DATA FORMAT Data Coding: Synchronous or Asynchronous A.4 DATA RATES Async 600bps to 19,200bps or Sync up to 19,200 with 38,400 bps com- posite A.5 DATA INTERFACE...
- Page 7 A.11 DIMENSIONS Height: 2.00 inches (5.08 cm) Width: 8.30 inches (21.08 cm) Length: 6.10 inches (15.49 cm) A.12 WEIGHT 2.25 lbs (1.02 Kg)
- Page 8 APPENDIX B JUMPER AND SWITCH SETTINGS Channel 1 Composite Channel 2 Power (Modem) (Terminal) (Terminal) Connector Character Length 25% Stop Bit Reduction = ON / 12.5% Stop Bit Reduction = OFF Factory Test, ” MUST BE SET TO “OFF Chan 1 Async = ON / Chan 1 Sync = OFF Signal Ground Connected to Chassis Ground = ON Factory Test Jumpers...