CAUTION
Once the Model 2701 is properly conÞgured, it is ready to connect to the
G.703/G.704 interface, to the serial port, and to the power source. This
section describes how to make these connections.
4.1 CONNECTING TO THE G.703 NETWORK
The Power, G.703/G.704 and serial Line connections are located on the
rear panel of the Model 2701. The following sections describe operation
of these connections.
Connecting the 2701/D (X.21 version) Dual Coaxial Cable
(75 ohm) to the G.703 Network
The Model 2701/D (X.21 version) is equipped with dual female BNCs
(TX and RX) for connection to a 75 ohm dual coax G.703 network inter-
face. If your G.703/G.704 network terminates via dual coaxial cable, use
the diagram below to make the proper connections. See Figure 3.
Figure 3. Rear Panel, Showing Location of Connectors.
Note
The outer conductor of the coax cables are isolated from system
earth ground.
When using the 75 Ohm interface, jumper straps JP2, JP5, JP6, and JP7
must be installed over the jumpers. The jumpers are located next to the
BNC connectors. Refer to the following section to open the case. Open
the case and install jumper straps for JP2, JP5, JP6, and JP7.
Opening the Case
Open the case by inserting a screwdriver into the slots and twist the
screwdriver head slightly. The top half of the case will separate from the
4.0 INSTALLATION
The Interconnecting cables shall be acceptable for
external use and shall be rated for the proper applica-
tion with respect to voltage, current, anticipated tem-
perature, flammability, and mechanical serviceability.
14