Quick Start - Wharfedale Pro MX-112 Operating Manual And User Manual

Quick-Start for Subwoofer Enclosures
(For quick setup of subwoofer enclosures)
- Make all initial connections with the power switches OFF on all equipment.
- Check that all master volumes, levels, or gain controls on all equipment are turned all the
way down.
- Connect the line-level outputs from the system mixer to the inputs of the electronic
crossover units. Connect the appropriate outputs of the crossover units to the appropriate
inputs of the high, mid and low frequency system power amplifiers.
- Connect the appropriate Speaker Output from the high-mid frequency power amplifiers
to the INPUT connectors on the full range or two-way speakers.
- Connect the appropriate Speaker Output from the low frequency power amplifiers to the
INPUT connectors on the MX Series subwoofers using appropriate speaker cables.
- Turn on the mixing console (or other signal source).
- With the level controls all the way down, turn on the amplifier.
- Send a signal source through the mixer, such as a microphone or instrument. Gradually
adjust the volume controls on the mixer and amplifier accordingly.
Subwoofer connections
Normal wiring connections from the output of the low frequency amplifier to the MX
subwoofer are made via NL4, Speakon-type connectors located on the rear mounted
input plate of each enclosure.
Connector pin wiring is configured as follows:
1+ = Positive
1- = Negative
MX Series
24