Note:
The default PIN code of the Powerline Extender can be found on its label or on its WPS configuration
page as shown in
Figure
You will see the following screen when the new device has successfully connected to the network.
Note:
a.
The WPS LED on the Powerline Extender will light green for five minutes if the device has been
successfully added to the network.
b.
The WPS function cannot be configured if the Wireless function of the Powerline Extender is
disabled. Please make sure the wireless function is enabled before configuring the WPS.
3.4 Network
You can configure the IP parameters of the Powerline Extender on this page.
TL-WPA281/TL-WPA271
The WPS Configuration Screen of Wireless Adapter
3-5.
Figure 3-8 Successfully Added a New Device
Figure 3-9 Network
Wireless N Powerline Extender
17