Table of Contents
Advertisement
12
Drive Shaft (Lower)
1. Loosen two (2) screws (B) and remove center locating screw (C).
Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and
re-coat with a thin coating [15 ml (1/2 oz.)] grease.
3. Slide the flexible cable back in the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and shield assembly.
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
s
Torage
Storage Hook Installation
1. Insert small end of hook into locating hole on attachment shaft.
2. Slide plastic cap onto end of attachment shaft.
s
peCIfICaTIons
Model ------------------------------------------------------- 99944200600
Shaft Length ------------------------------------------------ 870 mm (34.3 in.)
Attachment Width ----------------------------------------- 280 mm (11 in.)
Attchment Height ------------------------------------------ 255 mm (10 in.)
Weight (dry) w/blade -------------------------------------- 1.5 kg. (3.32 lb.)
Drive Shaft -------------------------------------------------- 6.35 mm (1/4 in.) Flex Shaft
Rotating Direction ----------------------------------------- Counter-clockwise viewed from the top
Cutter Attachment ----------------------------------------- 80 Tooth, 203 mm (8 in.) Metal Brush Blade
B
C
D
Advertisement
Table of Contents
