Air Filter; Automatic Oiler - Echo CS-301 Instruction Manual

Hide thumbs Also See for CS-301:
Table of Contents

Advertisement

C
B
D
F

aiR filteR

1. Close choke (A) (Cold Start Position [
A
2. Remove air filter cover (B). Brush dirt from inside cover.
3. Remove air filter (C) and lightly brush debris from filter.
4. If filter can be reused, be certain it:
5. Install air filter cover.

automatiC oileR

oil stRaineR
E
fuel stRaineR
18
dirt from entering the carburetor throat when the air filter
is removed. Brush accumulated dirt from air cleaner area.
Replace filter if it is damaged, fuel soaked, very dirty, or
the rubber sealing edges are deformed.
• Fits tightly in the air filter cavity.
• Is installed with the original side out.
The discharge volume of the automatic oiler is adjusted to
3 to 4 cc/min. (@ 7000 rpm) prior to shipment from the
factory.
Always check oil discharge when in use.
Turn adjusting screw (D) counter-clockwise to increase oil
volume, clockwise to decrease oil volume.
Check periodically.
-
Do not allow dust to enter into oil tank.
-
Clogged oil strainer will affect the normal
lubricating system.
-
Pick it up through oil port.
-
If the strainer (E) is dirty, wash it in gasoline.
-
When the inside of the tank gets dirty, rinsing the
tank out with gasoline will clean it.
Check periodically.
-
Do not allow dust to enter fuel tank.
-
Clogged strainer will cause difficulty in starting engine
or abnormalities in engine performance.
-
Pick up the fuel strainer (F) through fuel inlet port
with a piece of steel wire, or the like.
-
When the strainer is dirty, wash it in suitable
cleaning fluid.
-
When the inside of the fuel tank is dirty, rinsing the
tank out with suitable cleaning fluid will clean it.
]). This prevents

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents