Front Panel Features; Led Meter - EAW CXA120 Instruction Manual

Hide thumbs Also See for CXA120:

Table of Contents

3. FRONT PANEL FEATURES

1. EQ-LO

Turn this clockwise to boost the level of the low-frequency

range below 100 Hz. Turn it counter-clockwise to cut the

level. In the center position, there is no change in level.

The maximum boost and cut is 10 dB at 100 Hz.

2. EQ-HI

Turn this clockwise to boost the level of the high-frequency

range above 10 kHz. Turn it counter-clockwise to cut the

level. In the center position, there is no change in level.

The maximum boost and cut is 10 dB at 10 kHz.

3. VOLUME

Use this volume control to adjust the sound output level to

your speakers.

This meter shows the signal output level.

The left five LEDs represent the area between –20 dB and

0 dB. Adjust the Volume to keep your output within these

levels.

Turn down the Volume level so the two right LEDs do not

light, otherwise the outgoing signal will clip and distort.

5. POWER and POWER LED

Use this switch to turn the unit on or off. This connects/

disconnects the AC power to the AC power transformer.

The unit is on when the switch is pressed in, and the LED

above the power switch lights.

The unit is off when the switch is in the out position.

CXA120-AMPLIFIER

– CXA120

��

�

CXA120-AMPLIFIER

��

�

��

�

��

Table of Contents