Advertisement
Quick Links
To make your soup look that more appetizing you need to present it well, and the HotPot Soup Kettle from Dualit
does just that. You are able to keep your soup hot with both wet and dry heat, its inner water holder has
been made from aluminium which is solid cast, and its inner liner has been made from stainless steel. To avoid
evaporation and to keep your soup hotter for longer it has a stainless steel lid on a hinge that can be removed
easily for easy cleaning.
1.
Thoroughly wash the stainless steel inner pot and lid in warm soapy water
2.
The Dualit HotPot may be used either with WET heat (with water added) or DRY heat (with no water)
3.
For WET operation ONLY A 1/3 PINT OF WATER can be poured into the inner casting.
The water level MUST NOT exceed the height of the eight water level markers at the base of
the casting. The inner stainless steel container must NEVER float up, even when empty. Should it
do so the inner casting has been overfilled with waterand the excess water should be removed
immediatly.
4.
The temperature control should be set between 1 and 8 and this should provide enough
heat to keep the food at the correct temperture.
5.
For DRY OPERATION the simmerstat must be increased by ONE number to maintain the equivalent
temprature needed by the Wet method.
6.
The Dualit HotPot has been designed for easy maintenance; spilled food should be removed
immediatly from all exterior surfaces. The stainless steel bain marie and lid are mashine washable.
The aluminium exterior and top collar should be cleaned with detergent filled cloth.
IMPORTANT - NEVER IMMERSE THE KETTLE IN WATER AS THIS WILL MAKE THE
APPLIANCE EXTREAMLY DANGEROUS
7.
Should you remove the moulded on plug it should be rewired as follows:
Green and Yellow
Blue
Brown
WARNING - THIS APPLIANCE MUST BE EARTHED
If the supply cord is damaged, it must be replaced by a qualified person using a specially prepared
cord or assembly available from Dualit or Dualit service agent.
Always operate the Soup Kettle at the LOWEST possible temperature to save electricity costs.
8.
9.
The energy regulator set on ONE is the lowest temperature and set on TWELVE is the highest setting.
10.
A neon light will glow when the unit is turned on. Turn the dial to ZERO to isolate the HotPot from the
electricity supply.
11.
Display cards are provided on which you can display the type of product being served. This can be
hung from the hook under the rim near the top of the kettle or a magnetic label can be stuck on the
side of the kettle. A felt tip pen or wax crayon can be used to write on the cards.
REMEMBER - ONLY USE A 1/3 PINT OF WATER IN THE INNER CASTING.
Dualit Ltd County Oak Way Crawley West Sussex RH11 7ST +44 (0) 1293 652 500 +44 (0) 1293 652 555 e info@dualit.com www.dualit.com
SOUP KETTLE OPERATING INSTRUCTIONS
Earth
Neutral
Live
Advertisement
