Storing Channel Groups (Ensemble Learn); Wavelength; Navigation Via Lists; Scanning - Volvo XC60 Owner's Manual

04 Comfort and driving pleasure
Audio system

Storing channel groups (Ensemble learn)

When the vehicle is moved to a new broad-
casting area, programming of existing channel
groups in the area can take place.
Programming of channel groups creates an
updated list of all available channel groups.
The list is not updated automatically. Program-
ming takes place via the
menu or directly by means of a long press on
AUTO. If can take up to a minute to program a
Band III
04 channel group if both
selected.

Wavelength

DAB is transmitted on two wavelengths
III and LBand .
•
Band III – over the whole country
•
LBand
- mainly in large cities
By selecting for example
channel programming takes place more
quickly than if both Band III
selected. It is not certain that all channel
groups will be found. Wavelength selection
does not affect the stored memories.

Navigation via lists

There are three types of basic list which can be
used for navigation:
5 Not all areas/countries use both wavelengths.
6 During a build-up phase DAB will not cover the whole country but will only work in larger urban areas.
144
•
Ensemble list
that the receiver has obtained via channel
group programming.
•
Service list
of the channel group to which they are allo-
cated. The list can also be filtered using
DAB PTY
•
Subchannel list
Ensemble learn
selected channel.
The lists can be accessed via the menu. The
LBand
and are
channel groups can also be accessed by
pressing ENTER.

Scanning

5
; Band
Scanning means that all channels in the list are
played for 10 seconds each.
6
Press
Scanning can also be selected in DAB-PTY
mode. In which case only channels of the pre-
Band III on its own,
selected programme type are played.
and LBand are
Stop scanning by pressing SCAN once, or
by pressing EXIT.
Subchannel
Secondary components are usually named
subchannels. These are temporary and can
contain e.g. translations of the main pro-
gramme into other languages.
- Shows channel groups
- Shows channels irrespective
(see below).
- Subchannels to a
SCAN to activate.
If one or more subchannels are broadcast then
the > symbol is shown to the right of the chan-
nel name in the display. A subchannel is indi-
cated by the > symbol appearing to the left of
the channel name in the display.
To access a subchannel:
Press
To navigate between subchannels:
Press or
Subchannels can only be accessed on the
selected main channel and not on any other
one without selecting it.
DAB PTY (program type)
DAB PTY
selects one type of radio pro-
gramme. There are 29 different programme
types which also include different programme
categories. After selecting a programme type,
navigation only takes place within the channels
broadcasting that type.
Exit this mode as follows:
Press EXIT
It is also possible to select a preset channel or
exit DAB-PTY via the menu. In certain cases
DAB radio will exit PTY mode when DAB to
DAB linking (see below) is implemented.