Advertisement
Audio Output 2: Unswitched line level audio output to
an extenal amplifier. For locations that do not require
background music from the audio input.
Aux. Relay Output Contacts: DPDT relay contacts
that can be programmed as a timed event.
Internal 2-Watt Amp Gain Control: Adjusts
speaker output volume.
Aux. Relay Active LED
Secondary Aux. Relay Output Contacts:
Available on J9 solder pads.
Page Trigger Output Contacts: DPDT relay
contacts that activate when tones/messages are
played. Used for triggering paging amplifier, etc.
Page Activity LED:
Lights during tone/
message playback.
Audio Output LED:
Flashes to indicate tone/
message audio output.
RS485 Clock Sync
Output: For syncho-
nizing time on Viking
CL Series wireless
clocks (DOD# 466).
USB LED: Lights
indicating USB cable is
connected to a computer.
USB Programming Port: Type
B USB jack for programming
and uploading WAV files.
CO/Phone Line Input: Connect to
an unused phone line or PABX
station for atomic clock sync and/or
remote touch tone programming.
Trigger Inputs 1-4: For activating programmed
tones/messages. Programmable for NO, NC,
momentary, continuous, alternate action or
activate only.
Page Trigger 12VDC Output: Connect to paging
amplifiers requiring a switched 12VDC signal for
enabling the paging source input.
Speaker Output: 2 Watt maximum. Connect up to three
8-ohm speakers in parallel. This port is also useful for
monitoring WAV file audio during programming.
VIKING
©
VIKING
ELECTRONICS
HUDSON, WI 54016
ADVANCED CLOCK CONTROLLED
TONE / MESSAGE GENERATOR
- + - +
1 2 3 4 5 6
7 8 9 10
11 12 13 14 15 16 17
- + - +
MODEL CTG-2
- +
- +
18 19
20 21
- + - +
Time "+" Switch: Press to advance
through time, schedules, initiate a
force time sync or turn unit back on.
Time "-" Switch: Press to decrement
time, select schedules or turn unit off.
Master Volume: Used to adjust overall
pre-amp volume level output.
Audio Output 1: Line level audio output to
external amplifier. This output is switched for
use with existing paging or background music.
Audio Input: Line level pre-amp input for
paging, background music, etc.
PM LED: Lights to indicate
PM time.
Run LED: Lights to indicate unit
is in "RUN" (operation) mode.
Set Time LED: Lights to indicate
unit is in "Set Time" mode.
Set Schedule LED: Lights to
indicate unit is in "Set Schedule"
mode.
Force Time Sync LED: Lights
to indicate unit is ready for a
manual "Force Time Sync".
LED Display: Shows clock
time, schedule, force time
sync, on/off modes, sync
errors, system disable, etc.
Mode Switch: Press to
advance through modes
(run, set time, set schedule
or force time sync).
3
Advertisement
