Velodyne CHT-R SERIES User Manual page 11

(4) LINE OUTPUT
Connect these jacks to the LINE IN preamp input to use the CHT-R's internal high pass crossover. See
below for a more detailed explanation of this crossover.
(5) LINE INPUT/LFE Input
Connect these jacks to the LINE OUT preamp output, LFE output, or subwoofer output jacks of your
receiver/processor. If using the LFE output from your receiver or processor, plug the single cable into the
"L"– LFE input or, for more signal, use a "Y" connector and feed the signal into both "R" and "L" inputs.
(6) HIGH PASS CROSSOVER Switch
This switch selects the frequency for the high pass crossover. This crossover is functional on both line
and speaker-level outputs. Smaller speakers with limited low frequency output may perform better using
the higher 100 Hz setting that will reduce the low frequencies sent to them. Larger speakers with greater
low frequency output may be able to handle the 80 Hz setting without strain.
(7) SPEAKER LEVEL INPUT Terminals
Connect these input terminals to the speaker output terminals of your amplifier or receiver. If you use
this method of connection, when you go to the receiver speaker set up menu, make sure you select the
large speaker option.
(8) SPEAKER LEVEL OUTPUT Terminals
Sends a crossed-over speaker-level signal to the front speakers. See below for a more detailed
explanation of this crossover.
www.velodyne.com
CHT-R Series User's Manual - 5