Toshiba e-studio162 Operator's Manual page 23

Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove the cover, lift straight up
as shown. To replace the cover, do the reverse.
The ADF/RADF cannot be removed.
Using the ADF/RADF
• Originals that are 5-1/2" x 8-1/2" to 8-1/2" x 14" and 14 lbs. to 24 lbs.
Note
(52 g/m
placed at once.
• Straighten curled originals before placing them in the document
feeder tray. Curled originals may cause misfeeds.
• Place originals horizontally.
• Before placing originals in the document feeder tray, be sure to
remove any staples or paper clips from them.
• When a copy is made, the edges will not be copied (image loss).
For the image loss, see the "SPECIFICATIONS" (p.93).
• When using the margin shift function, check the position of the
margins carefully. (p.34)
1
Make sure that an original has not been left on the document
glass.
2
Adjust the original guides to the size
of the originals.
3
Set the original(s) face up in the
document feeder tray.
The ADF/RADF indicator on the operation
panel will light up. If this indicator does not
light up, the originals are not properly set or
the ADF/RADF is not properly closed.
4
Select the tray. "SELECTING THE TRAY" (p.23)
When the desired paper is not placed in any of the tray or the bypass tray.
• "CHANGING A TRAY'S PAPER SIZE SETTING" (p.19)
• "Loading paper in the bypass tray" (p.18)
5
Select the number of copies and other copy settings, and then
press the [START] key (
• The default output mode for copying from the ADF/RADF is sort
Note
mode (P.29), and a checkmark "
display (P.11). If "SORT AUTO SELECT" is disabled in the user
programs, the default output mode will be non-sort mode. (P.65)
• To stop copying in the middle of a run, press the [CLEAR] key (
• For the copy settings, see pages 23 through 35.
2 2
to 90 g/m ) can be used. A maximum of 30 pages can be
).
MAKING COPIES
Original face up
" will automatically appear in the
3
).
21