Installing The Phase 26 Usb Driver For Windows 2000 - TerraTec PHASE 26 USB Manual

Installing the PHASE 26 USB Driver for Windows 2000.

Important note: If the driver installation does not begin automati-
cally, you will have to update your firmware version. For more
information, please read section "Updating the firmware (Win-
dows)." on Ü page 16.
1. Make sure the ASIO mode is disabled on the device.
2. The "Found New Hardware Wizard" asks you to specify the location of the drivers for
the new hardware component "TerraTec PHASE 26 USB". Select the "Search for a
suitable driver for my device" option. Confirm by clicking "Next".
3. Enable the "Specify a Location" option and then click "Next". In the next dialog, enter
the path to the driver folder as <CD>:\Driver\Windows\PHASE26USB\ or the path to
your hard drive (usually C:\TerraTec\PHASE 26 USB\) and confirm with "OK". Confirm
the path in the Windows Wizard by clicking "Next".
4. The following dialog box may appear at this point or later in the installation:
This is no cause for alarm. Click "Yes" to continue. The installation will now be exe-
cuted.
If contrary to all expectations an additional request should appear for you to perform
some action and you are not sure about it, then pressing the Enter key is generally a safe
action. If Windows requests a second driver file, please refer to the aforementioned
directory on the PHASE CD-ROM or on your hard disk.
PHASE 26 USB (English) 11