Tannoy HTS Owner's Manual
  1. Manuals
  2. Brands
  3. Tannoy Manuals
  4. Speakers
  5. HTS
  6. Owner's manual

Tannoy HTS Owner's Manual

Hide thumbs

Advertisement

Table of Contents

Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for Tannoy HTS

Summary of Contents for Tannoy HTS

  • Page 1 Owner’s Manual...

  • Page 2: Table Of Contents

    WARRANTY HTS SET UP GUIDE ASSEMBLING THE TOWER SPEAKERS (HTS 201) ASSEMBLING THE CENTRE & SATELLITE (HTS 101) WALL BRACKETS POSITIONING THE HTS SPEAKERS CONNECTING THE HTS SPEAKERS TO YOUR A/V RECEIVER OR AMPLIFER GRILLES CARE OF CABINET TECHNICAL SPECIFICATIONS...

  • Page 3: Warranty

    To ensure maximum benefit from ownership and for reasons of safety, please read through all the information in this owner’s manual before operating and using this system for the first time. Tannoy HTS systems are primarily designed for use with the following equipment:- •...

  • Page 4: Assembling The Centre & Satellite (Hts 101) Wall Brackets

    4 ASSEMBLING THE CENTRE & SATELLITE (HTS 101) WALL BRACKETS Fit the wall brackets to the smaller satellite speakers if you wish to wall mount them, as follows: • Locate the appropriate screws and lock washers in the accessory pack - 2 screws for each wall bracket.

  • Page 5: Positioning The Hts Speakers

    5 POSITIONING THE HTS SPEAKERS Place the speakers in positions relative to the viewing screen in your room as follows: • Centre speaker close to, and either above or below the screen. • Front Left speaker 1 to 2 metres (approximately 3 to 6 foot) to the left of the screen.

  • Page 6: Connecting The Hts Speakers To Your A/V Receiver Or Amplifer

    RIGHT 7 GRILLES The HTS grilles have been designed to provide acoustic transparency. However, for ultimate fidelity the enthusiast will appreciate the slight improvement in clarity and detail that is achieved by removing the grilles during listening. 8 CARE OF CABINET...

  • Page 7: Technical Specifications

    9 TECHNICAL SPECIFICATIONS SATELLITE Recommended amplifier power 25 – 100 Watts (RMS) Sensitivity (2.82V @ 1m) 87dB Nominal impedance 8 Ohms Frequency response (-6dB) 100Hz – 40kHz Drivers HF: 19mm (3/4”) titanium WideBand dome, with neodymium magnet system LF: 75mm (3”) paper cone Crossover Frequency 3kHz (LF to HF) Magnetic shielding...
  • Page 8 T: 00 971 (04) 4401208 E: enquiries@tannoy.com TC|Group International T: 00 45 8742 7000 E: info@tcgroup-international.com TC|Group Americas T: 00 1 (519) 745 1158 E: info@tcgroup-americas.com Tannoy adopts a policy of continuous improvement and product specification is subject to change. tannoy.com...

Table of Contents