Table of Contents
Advertisement
Configuring your network
Configuring your network
Completing the configuration
Configuring interface 3
50
Figure 7: FortiGate-400 NAT/Route mode connections
If you are running the FortiGate unit in NAT/Route mode, your networks must be
configured to route all Internet traffic to the IP address of the FortiGate interface to
which they are connected.
Use the information in this section to complete the initial configuration of the FortiGate
unit.
Use the following procedure to configure interface 3 to connect to a network:
1
Log into the web-based manager.
2
Go to System > Network > Interface.
3
Choose port3 and select Modify
4
Change the IP address and Netmask as required.
5
Select Apply.
.
NAT/Route mode installation
Fortinet Inc.
- Quick Links:
- Deleting Addresses
Hide quick links:
Advertisement
Table of Contents
