Sonnet Tempo Ultra ATA66 Installation Manual page 31

Install Tempo Ultra ATA66
1. Select an available PCI slot to install the Tempo
and remove its access port cover (Figure 4).
2. Remove the Tempo from the anti-static
package, making sure to handle the board
by the edges.
3. Attach the host connector on the Ultra ATA66
cable to the connector closest to the bracket on
the Tempo (Figure 5); if you are unfamiliar
with the Ultra ATA66 cable connectors, see
page ix, for further information.
4. Align the Tempo over the PCI slot (Figure 6).
Gently press down until it is firmly seated in
the PCI slot, taking care not to wiggle the
board as you install it into the slot.
5. The current internal hard drive's power cable
should have an additional drive power
connector. Thread the power connector along
with the Ultra ATA66 cable through the
opening of the drive sled (Figure 7).
access port cover
Figure 4
bracket
Figure 5
Tempo
PCI slot
Figure 6
Ultra ATA66 cable
additional power
connector
Tempo
Figure 7
opening in
drive sled
5-3