Mounting Brackets; Jumper Block - Sonnet Tempo Ultra ATA66 Installation Manual

Mounting Brackets

Most drives need to be outfitted with mounting
brackets before being installed into a computer.
Please refer to our computer and/or drive's user
guides for details.

Jumper Block

Prior to installing a drive, you will need to configure
it as either a primary (master) or secondary (slave)
drive. Figure 1 lists common jumper settings.
Most drives are factory preset as a master drive. To
change the setting, you will need to reconfigure the
position of the jumpers located in the jumper block.
The jumper block is located at the rear of the drive
(Figure 2), or on the drive's exposed printed circuit
board (Figure 3). The location of the jumper block
and position of jumper pins vary depending on the
manufacturer of the drive. Refer to your drive's user
guide or the jumper setting information printed on
your drive.
Support Note:
drive's jumper pins, verify the orientation
of the drive with respect to the illustration. llustra-
tions may vary.
2-2
When configuring your
Common Drive Jumper Settings
Master Jumper selection for the primary drive of two drives
installed on the same ATA cable
Master/Single Jumper selection for the primary drive of two drives
installed on the same ATA cable (designated as only
master on some drives) / Jumper selection for a single
(primary) drive on an ATA cable.
Single Jumper selection for a single (primary) drive on an
ATA cable
Slave Jumper selection for the secondary drive of two drives
installed on the same ATA cable
Cable Select Jumper selection for special drive cable configurations;
Rarely used and not supported with the Tempo
Figure 1
Jumper block
Figure 2
Figure 3
Jumper block