Amana Room Air Conditioner & Heat Pump Use And Care Manual page 10

Ins tallation Ins tructions
8
INS TALL THE AIR CONDITIONER
IN THE CASE
Slide the air
A
conditioner into
the case. Do not
push on the
controls or the
finned coils.
Make sure the
air conditioner
is firmly seated.
Reinstall the locking bracket and screw
B
removed earlier .
Reconnect the ground wire to the air
C
conditioner using the screw removed earlier
IMPORTANT: The ground wire must be
reinstalled to ensure a proper ground.
Remove the front grille from its box and
D
remove the shipping tape.
Grasp the inlet grille at the bottom corners
E
and pull it forward. Unhook it from its top
hinges and set it aside.
Using the tab, pull up slightly on the filter
F
to release it and pull it down and out.
8
INSTALL THE AIR CONDITIONER
IN THE CASE (cont.)
Pull the coiled power cord from its shipped
G
position in the air discharge area. Attach
the front grille frame to the case by inserting
the tabs on the grille frame into the slots
on the front top of the case. Push the grille
frame in. And install the 2 side screws at bottom
left and right side of front panel.
Guide the lever carefully
through the grille fram e
as you pus h it in.
.
Secure the front grille frame to the case
H
with one type C screw .
Reinstall the filter .
I
Reinstall the inlet grille. Connect power
J
10
.