Silver King SKFS2 Technical Manual And Replacement Parts List

Mobile freezer
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Technical Manual
and

Replacement Parts List

Mobile Freezer
MODEL
SKFS2
1600 Xenium Lane North, Minneapolis, MN 55441-3787
Phone (763) 923-2441
FORM 31451 REV K
Specifications Subject to Change Without Notice.
1

Advertisement

Table of Contents
loading

Summary of Contents for Silver King SKFS2

  • Page 1: Replacement Parts List

    Technical Manual Replacement Parts List Mobile Freezer MODEL SKFS2 1600 Xenium Lane North, Minneapolis, MN 55441-3787 Phone (763) 923-2441 FORM 31451 REV K Specifications Subject to Change Without Notice.
  • Page 2: Installation

    Please read this manual and the accompanying warranty information before operating your new Silver King unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty. UNCRATE AND INSPECT FOR DAMAGE Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following the instructions printed on the exterior of the container.
  • Page 3: Operation

    Defrost The Silver King freezer is a manual defrost unit. The unit should be defrosted whenever the walls accumulate a frost layer that is 1/4 inch thick. To defrost the unit, either turn the Temperature Control stem to the ‘off’ position (fully counterclockwise) or disconnect the Power Cord from the electrical receptacle, and remove or open the Lid Assembly.
  • Page 4 Sírvase leer este manual y la información acerca de la garantía que lo acompaña antes de poner en funcionamiento su nueva unidad Silver King. Asegúrese de completar y enviar por correo la tarjeta de garantía dentro de los 10 días posteriores a la compra a fin de ratificar su garantía.
  • Page 5: Mantenimiento

    Espere un mínimo de dos horas para que la unidad responda a un ajuste de control. Descongelamiento El expendedor de mercaderías para mostrador Silver King es una unidad de descongelamiento manual. La unidad debe ser descongelada cada vez que las paredes acumulen una capa de escarcha de un grosor de 0,63 centímetros (1/4 pulgada).
  • Page 7 WHEN ORDERING REPLACEMENT PARTS, PLEASE PROVIDE MODEL AND SERIAL NUMBERS.

Table of Contents