Ford ESCAPE HYBRID FCS-14265-05 Emergency Response Manual page 6

ESCAPE HYBRID OR MARINER HYBRID COMPONENTS IDENTIFICATION
Please note the location of the following unique Hybrid components. Refer to the
vehicle component location graphic on the following page.
Component
1 Rear Inertia Switch
2 High Voltage Service
Disconnect Switch
3 High Voltage Battery
(300+ volts)
4 High Voltage Wiring
5 12 Volt Battery
6 ECVT (Electronically
Controlled
Continuously Variable
Transmission )
7 DC/DC Converter
8 Front Inertia Switch
NOTE: All High Voltage wires and harnesses are wrapped in orange-colored insulation.
FCS-14265-05
Location
Passenger side. Behind right
rear trim panel
The High Voltage Service
Disconnect Switch is located
on the top, passenger side, of
the high voltage battery. It has
a molded plastic handle that
is safety orange in color for
easy identification. The high
voltage battery is located
below the floor carpet in the
rear of the vehicle.
Rear of vehicle – below
carpet
Orange wire – Runs along the
bottom of the vehicle between
the high voltage battery and
the ECVT (Electronically
Controlled Continuously
Variable Transmission). Also
connects ECVT to the DC to
DC converter
Driver side of vehicle. Under
hood – front
Same position as a traditional
transaxle
Passenger Side . Under hood.
Located in front of the shock
tower
Passenger compartment,
passenger side, front seat,
lower kick panel
6
2006/07 Escape Hybrid, Mariner Hybrid Emergency Response Guide, 08/2006
Description
The inertia switch disconnects high
voltage and fuel in a collision -see
page 8.
Provides high voltage battery
disconnect for service. It has a
molded plastic handle that is safety
orange in color for easy identification,
Sealed Nickel-Metal Hydride – 300 +
volts.
Connects high voltage battery to
ECVT Connects ECVT to DC to DC
converter. All high voltage wires and
connectors will be orange.
Provides 12 volt power to the vehicle
– Traditional lead /acid battery.
Contains the traction motor,
generator motor and hybrid
electronics.
Provides 12 volt power to charge the
battery and run 12V electrical
accessories
The inertia switch disconnects the
high voltage circuit and the electrical
circuit to the gasoline fuel pump in a
collision