Embedded Applications - Wavecom Gx64 Application Note

4.6

Embedded Applications

Optitrace is also used to enable debugging of the embedded applications if you are
using it. To enable the prtf traces to be received by Optitrace the following needs to
be set in the filters.
GS – GLTraceHigh
It is recommended that the following is also set as it gives an insight into what is
happening internally to the embedded applications interpreter which might in turn
help with debugging the software.
Wavecom - EmbeddedAppsError
Wavecom - EmbeddedAppsWarning
Wavecom - EmbeddedAppsCommandInfo
Wavecom – EmbeddedAppsCommandFunction
Note : If you are using the prtfdir function to redirect the traces to UART1 then you
do not need to use Optitrace, in this case you only require a terminal program. If the
UART is set to auto baud then terminal will need to send 'at' to the unit so that it
knows what baud rate to output the debug information.
Gx64 APPLICATION NOTE
Using Optitrace
Page: 14/18
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son autorisation préalable