Table of Contents
Advertisement
This command sets the value of the TA defined character to be used as line formatting character when
formatting the result codes and information text. It is used together with the ATS3 command.
The formatting character setting is not persistent. As a result, it is not saved after a power cycle.
Parameter
<value>
0 – 127
4.8.5
ATS5 (Command Line Editing Character)
Description
Sets the current setting
Reads the current setting.
This command sets the value of the defined character for deleting the immediately preceding character from
the command line.
The delete character setting is not persistent. As a result, it is not saved after a power cycle.
Parameter
<value>
0 – 127 (default is 8)
4.8.6
ATS6 (Pause before Blind Dialing)
Description
Sets the current setting
Reads the current setting.
This command sets the number of seconds to pause before blind dialing register value of V.25 ter. It is
provided only for compatibility with the V.25 register command, there is no action performed on the CM52.
The pause value setting is not persistent. As a result, it is not saved after a power cycle.
Parameter
<value>
2-10 (default is 2)
4.8.7
ATS7 (Connection Completion Timeout)
Description
Sets the current setting
Description
line formatting
Decimal values for the line formatting character. The default is 10, or the
ASCII line feed character.
Syntax
ATS5=<value>
ATS5?
Description
backspace character
Decimal values for the command line-formatting character.
Syntax
ATS6=<value>
ATS6?
Description
Pause value in seconds.
Syntax
ATS7=<tmo>
Confidential
USERS MANUAL
Document number
1/198 17-4/FCP 101 3045 Uen
Possible responses
OK
<value>
OK
Possible responses
OK
<value>
OK
Possible responses
OK
69(158)
Revision
D
Advertisement
Table of Contents
