Table of Contents
Advertisement
If you discover the battery life is getting shorter, please
perform the "Battery Calibration" process immediately.
R
e
m
o
v
i
n
g
t
h
e
R
e
m
o
v
i
n
g
t
h
e
To remove the battery pack from its compartment, please refer to
Chapter 3, Inserting and Removing the Battery Pack.
Preparing the Battery Pack for Use (Battery
Calibration)
Before using the battery pack for the first time, the Smart Battery
IC within the battery pack should be calibrated in order to get
accurate reporting of remaining battery life status.
To calibrate the battery pack follows the instructions below:
Insert the battery into the battery compartment and turn on the
1.
notebook. If the battery is completely without power go to the
next step. Otherwise, let the battery run down until the
battery low-low warning beeps are heard. The system will
automatically enter Suspend mode.
2.
Turn the notebook off. Connect the AC adapter and let the
battery fully recharge. When the battery charge indicator
turns off, the battery is fully charged.
Turn On the notebook, let the battery run down until the
3.
battery is in low-low state and you hear a warning beeps.
The system will automatically enter the Suspend mode. You
can now connect the AC adapter.
The battery pack is now calibrated properly.
4.
In general, using the battery until the low-low battery-warning
indicator appears and fully recharges the battery each time (full
discharge/charge cycle) will ensure the accurate reporting of the
battery gauge status.
Automatic Battery Pack Charging Function
To charge the battery, while the battery pack is in the notebook,
plug the AC adapter into the notebook and an electrical outlet.
The charging time is approximately 2.5 hours when the notebook is
turned off and approximately 3.5 hours when the notebook is
turned on. When the battery is fully charged, the battery charge
indicator becomes off.
24
B
a
t
t
e
r
y
P
a
c
k
B
a
t
t
e
r
y
P
a
c
k
Advertisement
Table of Contents
