Mechanical Installation; Wall Mount - Aprilaire 8100 Installation Instructions Manual

MECHANICAl INSTAllATION

WAll MOUNT

The unit can be mounted on a concrete wall or on a stud wall . The mounting
bracket is pre-drilled for fastening to standard 16" O . C . or 24" O . C . stud spacing .
Remove the access panel, EnergyMax Transfer Core, and air filters for installation .
1 . Remove the access panel, EnergyMax Transfer Core and filters . (See figure 4 .)
2 . for Stud Wall: Fasten the supplied mounting bracket to the wall using the
supplied lag bolts and washers . (See figure 5 .)
for Concrete Wall: Fasten the supplied mounting bracket to the wall using
field supplied concrete anchors and the supplied lag bolts and washers .
3 . Insert the supplied hanging pin in the left hole of the mounting bracket and
secure by inserting the supplied washer and hand tightening with the supplied
nut . (See figure 5 .)
4 . Insert the supplied hanging pin in the right hole of the mounting bracket . (See
figure 5 .)
5 . Fasten the hanging hook bracket to the left side of the unit with the supplied
10-32 x 3/8" machine screws, using the pre-tapped holes along the side of the
unit . (See figure 6 .)
6 . Fasten the supplied hanging hinge bracket to the right side of the unit with
the supplied 10-32 x 3/8" machine screws, using the pre-tapped holes along
the side of the unit . (See figure 6 .)
7 . Pick the unit up and hook the hanging hook bracket on the left hanging pin .
(See figure 7 .) Note: Keep pressure against the unit to prevent it from
swinging away from the wall.
8 . Push the unit against the bracket, remove the right side pin, align the hanging
hinge hook with the bracket and reinsert the hanging pin . Secure the pin by
inserting the supplied washer and tightening the supplied nut . (See figure 8 .)
9 . Securely tighten the nut on the left side of the unit .
10 . Reinstall the EnergyMax Transfer Core, air filters and access panel .
fIGURE 6 – Installing Mounting brackets
HOOK BRACKET
(hook points out)
LEFT END
fIGURE 7 – Hanging left Side of ERV
HINGE BRACKET
4
HINGE BRACKET
(hinge points out)
RIGHT END
HANGING
MOUNTING
PIN
BRACKET
HOOK BRACKET
90-1742
fIGURE 4 – Removing Core and filters
90-1741
fIGURE 5 – Installing Mounting bracket
on Wall
HANGING PIN
WASHER
MACHINE SCREWS
HOOK BRACKET
fIGURE 8 – Hanging Right Side of ERV
ENERGYMAX
TRANSFER CORE
HANGING PIN
MOUNTING BRACKET
LAG BOLT
AND WASHER
THREADED NUT
MACHINE SCREWS
HINGE BRACKET
HANGING PIN
MOUNTING BRACKET
HINGE BRACKET
WASHER
THREADED NUT
FILTER
FILTER
90-1735
90-1734
90-1736