Cloning Your Hard Drive With Clone Ez - Apricorn ez upgrade 1.8t User Manual

B. Cloning your hard drive with Clone EZ
1. Read all instructions carefully before cloning. To clone your
hard drive, you will need to boot directly to EZ Gig II CD. These
steps are a quick walk through of how to use Clone EZ. For
detailed instructions and explanations, access the Clone EZ
manual on the EZ Gig II CD.
2. Make sure your computer is off.
3. Connect EZ Upgrade 1.8T to your computer with the Mini-B to
USB cable provided.
4. Open the CD-ROM drive (some computers may need to be
turned on in order to open the CD-ROM Drive). Place the EZ
Gig II CD into the CD-ROM drive. Close the CD-ROM drive.
Make sure computer is turned off.
5. Turn on your computer and change the BIOS setting so that
the computer boots to the CD-ROM. Consult your computer
manufacturer or computer manual on how to make changes
to the BIOS (basic input/output system).
Before you make any changes to the BIOS, record the settings
on a sheet of paper and keep this in a safe place. This is just in
case of any mishaps and will help you restore your computer
to its original settings if needed.
Once you have accessed the BIOS and recorded the settings,
change the boot sequence so that CD-ROM is the fi rst
selection.
6. Save the changes and continue with cloning your hard drive.
7
Value You Can Depend On