Hard Drive Installation Sata; Connecting The Cables - Apricorn EZ Upgrade Upgrade Kit

Hard Drive Installation (cont'd)
Step 2 SATA instructions for inserting the hard drive.
Separate the grey plastic base (grey sled with circuit board) from the
upper case to allow the drive to slide in cleanly. With the label side up
place the hard drive between the grey sidewalls (which will act as a
guide) properly aligning the SATA blade connector with the black socket
on the EZ Upgrade circuit board inlay. Carefully slide the hard drive by
placing your thumb on the back edge and pushing it towards the black
socket until it is seated. The back edge of the hard drive will be flush
with the end of the grey plastic base when it is completely seated.
For Upgrades Proceed to Step 4. To permanently mount your old hard
drive proceed to Step 3.
Step 3 Turn over the circuit board and attach the hard drive with screws. Align
the latches of the lower case and upper case.
Step 4 Close the case by reversing the process described in step 1. Install the
fastening screw on the underside of the case to complete the assembly.
You may need to connect two cables to the EZ Upgrade in order to
power the product correctly.
Step 1 For the Auxhiliary USB power cable: Plug the appropriate end into the
AC Adapter connector port on the EZ Upgrade and then connect the USB
side of the cable into an open USB port on your computer.
Step 2 For the USB Type B to USB cable: Plug USB Type B end into the open
port on the EZ Upgrade and then connect the other side of the cable
into a second open USB port on your computer.
USB Type B port and connector
Note: When using two cables always plug the auxhiliary USB
power cable in first and the USB Type B to USB connector last.
EZ Upgrade

Connecting the Cables

www.apricorn.com
Hard Drive Upgrade Kit
pg.