Table of Contents
Advertisement
Follow these steps to install the Hard Disk into the EZ Upgrade Enclosure:
Step 1 Turn the housing over and remove the set screw on the underside of
the lower case. Now, grasp the lower case and slide it backward for
approximately 1/4 inch, then lift it to separate from the upper case.
Step 2 PATA instructions for inserting the hard drive.
Separate the grey plastic base (grey sled with circuit board) from the
upper case to allow the drive to slide in cleanly. With the label side up
align the gold pins on the hard drive with the black socket on the EZ
Upgrade circuit board inlay. The sidewalls of the grey plastic base will
act as a guide, properly aligning the gold pins with the black socket and
ensuring a proper connection. Carefully slide the hard drive by placing
your thumb on the back edge and pushing it towards the black socket
until it is completely seated. If parts of the pins are still visible, the drive
is not completely seated.
pg.
EZ Upgrade
Hard Drive Installation
www.apricorn.com
Hard Drive Upgrade Kit
Advertisement
Table of Contents
