Installing The X-Video Card - Apogee X-Video Card User Manual

X-Video – User's Guide

Installing the X-Video card

2
4
3
Plastic standoff here
6
8
Your X-Video card should include the following:
1 X-Video circuit board
1 X-Video Coverplate
2 aluminium standoffs
1 plastic standoff
1 manual
1 Remove the top cover of Big Ben.
2 Remove the Option Card coverplate, and set aside the screws for
later use.
3 Remove the two interface circuit board screws indicated at left, and
set them aside for later use
4 Install the two aluminium standoffs in the threaded holes vacated
by the screws.
5 On the X-Video card, install the plastic standoff in the hole adjacent
to the multi-pin motherboard connector.
6 Install the X-Video Coverplate, and secure it to the host interface
using two screws from Step 2.
7 Insert the BNC connector end of the X-Video card through the ap-
propriate cutouts in the coverplate, and carefully place the multi-pin
motherboard connector in the mating connector found on the host
interface motherboard.
8 After verifying the alignment of the multi-pin and the mating con-
nectors, firmly press down on the X-Video card, over the connector,
until the pins are completely seated in the mating connector.
9 Re-install the circuit board screws from Step 3 in the locations
indicated below.
10 Replace the top cover of Big Ben.
9
4