Page 1
J PRE 500 ® ® JENSEN TRANSFORMER COUPLED MIC PRE 500 SERIES MODULE Owner’s Manual...
Page 2
European Union rules, regulations, and guidlines for use. Do 3. Connect the equipment into an outlet on a circuit different from not attempt to modify or change the J PRE 500, as this could void that to which the receiver is connected.
Page 3
3.3 Output Level Switch 3.4 -26dB Pad 3. Pull your J PRE 500 module out of its box and carefully slide 3.5 Phase it into place in the designated opening. Sight down the back of 3.6 75Hz High Pass Filter the module (use a flashlight if necessary) and ensure the card 3.7 48V Phantom Power...
However, some inexpensive computer audio interfaces have a maximum input level of less The J PRE 500 mic pre is inspired by the Aphex flagship 1788A than +16dB. Most also offer a -20dB pad to preamp. They both use the same Jensen JT11K8 nickel input Trans- address these kind of issues.
EXCLUSION OF CERTAIN DAMAGES Aphex Systems’ liability for any defective unit is limited to the repair or replacement of said unit, at our option, and shall not include damages of any other kind, whether incidental, consequential, or otherwise.
Unbalanced: 20KΩ Nominal Level: +4dBu OUTPUT - (+4 LEVEL) Maximum Level: +24dBu CMRR: >40dB COMMON This product is protected under one or more of the following Aphex patents. (unused) OUTPUT (unused) 6,266,423 Impedance: 110Ω INPUT- (+4 LEVEL) Nominal Level +4dBu...
Need help?
Do you have a question about the J PRE 500 and is the answer not in the manual?
Questions and answers